Clifford IntelliGuard 950 Owners Guide - Page 25
manual programming instructions
View all Clifford IntelliGuard 950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
manual programming instructions It is a good idea to document changes by taking note of all feature changes made in programming mode. To enter the User Selectable Features programming: 1. Ignition on - Turn the ignition to the run position or start the engine. 2. Enter PIN - Enter the factory preset PIN code. note: If the factory preset PIN has been changed, the new PIN must be entered. 3. Hold/Chirp/Release - After entering the PIN code, press and hold until a chirp is heard and the LED turns on, then release the button. You have now entered the feature selection position of the User Selectable Features grid. 4. Column select - Press the same number of times as the desired column. After a pause the siren will chirp the same number of times as the selected column for confirmation. 5. Feature select - Press the same number of times as the desired feature. The siren will chirp with each press. The feature can now be changed using the remote control. 6. Feature change - Press on the transmitter. If the sys- tem chirps once, the feature has just turned off; if the sys- tem chips twice, the feature has just turned on. If the fea- ture has more than two settings, continue pressing on the transmitter to toggle through the settings. You can advance to any feature in the same column by pressing within 60 seconds; to program a feature in a different column begin at step 4 within 60 seconds. 22