Clifford IntelliGuard 950 Owners Guide - Page 33

ultrasecure auto-immobiliser

Get Clifford IntelliGuard 950 PDF manuals and user guides View all Clifford IntelliGuard 950 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

d. Press and release two times, and then press once. You will hear two chirps. 4. Wait for two siren chirps after a five second pause or five seconds after the last digit has been entered if using less than four digit code number. 5. Turn off the ignition; the siren will chirp three times. 6. The programming mode is now exited. PIN Code Confirmation Procedure Begin this procedure within 15 seconds of finishing the programming sequence or the new code will not be set. 1. Turn on the ignition. 2. Enter the new PIN code. 3. Press and hold for three seconds. z LED turns on: New PIN code is learned and programming is complete. z LED stays off: New PIN code is not learned and the system reverts to the old PIN code. Redo the programming sequence. ultrasecure auto-immobiliser The built-in dual circuit immobiliser autoimmobilises (arms automatically), 30 seconds after the ignition has been turned off. (This feature is a Thatcham and EC requirement and, therefore is not programmable.) 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
30
d.
Press and release
two times, and then press
once. You will hear two chirps.
4.
Wait for two siren chirps after a five second pause or five
seconds after the last digit has been entered if using less
than four digit code number.
5.
Turn off the ignition; the siren will chirp three times.
6.
The programming mode is now exited.
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming
sequence or the new code will not be set.
1.
Turn on the ignition.
2.
Enter the new PIN code.
3.
Press and hold
for three seconds.
LED turns on: New PIN code is learned and program-
ming is complete.
LED stays off: New PIN code is not learned and the sys-
tem reverts to the old PIN code. Redo the programming
sequence.
ultrasecure auto-immobiliser
The built-in dual circuit immobiliser autoimmobilises (arms automatical-
ly), 30 seconds after the ignition has been turned off. (This feature is a
Thatcham and EC requirement and, therefore is not programmable.)