Craftsman 21194 Operation Manual - Page 19

result

to the

blade,

table

insert or

turntable

if blade strike occurs

during

the

cutting operation.

1. To remove, loosen and remove the

six screws

(1) on the table inserts

(2) with a Phillips screwdriver

and

remove the insert.

2.

To install, reposition

the table

inserts, install the six screws and

tighten.

3.

Check for blade clearance

by

moving the slide carriage through

the full motion of the blade in the

table slot.

Fig. G

2

MOUNTING

THE MITER SAW

(FIG.

H, i)

®

®

handle.

Carrying

the tool

by the

power cord could cause

damage

to the

insulation

or the wire

connections

resulting

in

electric

shock

or fire.

To avoid injury

from

flying

debris,

do

not

allow

visitors

to

stand

near the

saw

during

any cutting

operation.

Support

the saw on a level

work

surface.

Always

bolt or clamp

the saw to

its

support.

Mounting

instructions

1.

For

stationary

use, place the saw

in the desired location, directly on a

workbench

where there

is

room for

handling

and proper support of the

workpiece.

The base of the saw has

four mounting

holes. Bolt the base

of the miter saw (1) to the work

surface (5), using the fastening

method as shown in Fig H.

Fig. H

[,_

i

1.

Miter saw base

WARNING

2.

Hex head bolt

To avoid

injury

form

unexpected

3.

Rubber washer

saw movement:

4.

Flat washer

o

Disconnect

the power

cord

from

5. Workbench

the outlet,

and lock the cutting

6.

Flat washer

7.

Lockwasher

head in

the lower

position

using

8.

Hex nut

the

stop

latch.

9. Jam nut

o

Lock the

slide

carriage

in

place

by tightening

the

slide

carriage

lock knob.

o

To avoid

back

injury,

lift the

saw

by using

the designated

carrying

handles

located

on the top of the

machine.

When

lifting,

bend at

2.

your

knees,

not from

your

back.

o

Never carry

the miter saw

by

3

4

1

--r-

"

k

I

NOTE:

Mounting

hardware is not

included with this tool. Bolts, nuts,

washers,

& screws must be purchased

separately.

the

power

cord

or by the

switch

For

portable

use, place the

saw on a 3/4 in. thick piece of

plywood. Bolt the base of the

Craftsman 21194 Operation Manual - Page 19

The Miter Saw

Page 19 highlights