Craftsman 21194 Operation Manual - Page 25

The maximum

Get Craftsman 21194 - 7-1/4 in. Sliding Compound Miter Saw PDF manuals and user guides View all Craftsman 21194 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

SETTING CUTTING DEPTH (FIG. S) The depth of cut can be preset for even and repetitive shallow cuts. 1. Adjust the cutting head down (See CUTTING HEAD section) until the teeth of the blade are at the desired depth. 2. While holding the upper arm in that position, turn the stop knob (1) until it touches the stop plate (2). 3. Recheck the blade depth by moving the cutting head front to back through the full motion of a typical cut along the control arm. . Adjust the stop knob (1) to touch the stop plate (2). 3. Recheck the blade depth by moving the cutting head front to back through the full motion of a cut along the control arm. If the blade touches the inside of the control arm, readjust the setting. Fig. S 2 ADJUSTING CUTTING DEPTH (FIG. S) The maximum depth travel of the cutting head was set at the factory. Check to see that the blade does not extend more than 1/4 in. below the table insert, and does not touch the control arm throat or any part of the base or table, if the maximum depth needs readjusting: 1. Loosen the stop knob (1) while moving the cutting head down until the blade extends just 1/4 in. below the table insert.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
SETTING
CUTTING
DEPTH (FIG. S)
The depth of cut can be preset for
even
and repetitive shallow cuts.
1.
Adjust the cutting head down (See
CUTTING
HEAD section) until the
teeth of the blade are at the desired
depth.
2.
While holding the upper arm
in
that
position, turn the stop knob (1) until
it
touches the stop plate (2).
3.
Recheck the blade depth by moving
the cutting head front to back
through the full motion of a typical
cut along the control arm.
Fig.
S
.
3.
Adjust the stop knob (1) to touch
the stop plate (2).
Recheck the blade depth by
moving the cutting head front to
back through the full motion of a cut
along the control
arm. If the blade
touches the inside of the control
arm, readjust the setting.
2
ADJUSTING
CUTTING
DEPTH
(FIG. S)
The maximum
depth travel of the
cutting head was set at the factory.
Check to see that the blade does not
extend more than 1/4 in. below the
table insert, and does not touch the
control arm throat or any part of the
base or table, if the maximum
depth
needs readjusting:
1.
Loosen the stop knob (1) while
moving the cutting head down until
the blade extends just 1/4 in. below
the table insert.