Cub Cadet CC 600 Operation Manual - Page 16
Problem, Cause, Remedy
View all Cub Cadet CC 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Problem Mower will not mulch grass (if equipped) Cause 1. Wet grass. 2. Excessively high grass. Mower will not catch grass (if equipped) Uneven cut 3. Dull blade. 4. High lift bagger blades installed. 1. Dull blade. 2. Mulcher blades installed. 1. Wheels not positioned correctly. Mower will not self propel High pullback effort 2. Dull blade. 1. Belt not installed properly. 2. Debris clogging drive operation. 3. Damaged or worn belt. 1. Pulling mower backwards before transmission disengages. Remedy 1. Do not mow when grass is wet; wait until dry to cut. 2. Mow once at a high cutting height, then mow again at desired height or make a narrower cutting path. 3. Sharpen or replace blade. 4. Install mulcher blades. 1. Sharpen or replace blade. 2. Install high lift bagger blades. 1. Place front and rear wheels in same height position. (Rear Wheel/Caster Wheel height adjusters only) 2. Sharpen or replace blade. 1. Check belt for proper pulley installation and movement. 2. Stop engine, disconnect spark plug boot, and clean out debris. 3. Inspect and replace belt. 1. Allow the unit to roll forward slightly without the drive lever(s) engaged before pulling backwards. 16 Section 5- Troubleshooting