D-Link DES-3852 Product Manual - Page 307
VRRP Commands, Purpose, Syntax, enable vrrp {ping}, Description, Parameters, Restrictions
UPC - 790069289460
View all D-Link DES-3852 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 307 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual 43 VRRP COMMANDS VRRP or Virtual Routing Redundancy Protocol is a function on the Switch that dynamically assigns responsibility for a virtual router to one of the VRRP routers on a LAN. The VRRP router that controls the IP address associated with a virtual router is called the Master, and will forward packets sent to this IP address. This will allow any Virtual Router IP address on the LAN to be used as the default first hop router by end hosts. Utilizing VRRP, the administrator can achieve a higher available default path cost without needing to configure every end host for dynamic routing or routing discovery protocols. Statically configured default routes on the LAN are prone to a single point of failure. VRRP is designed to eliminate these failures by setting an election protocol that will assign a responsibility for a virtual router to one of the VRRP routers on the LAN. When a virtual router fails, the election protocol will select a virtual router with the highest priority to be the Master router on the LAN. This retains the link and the connection is kept alive, regardless of the point of failure. To configure VRRP for virtual routers on the Switch, an IP interface must be present on the system and it must be a part of a VLAN. VRRP IP interfaces may be assigned to every VLAN, and therefore IP interface, on the Switch. VRRP routers within the same VRRP group must be consistent in configuration settings for this protocol to function optimally. The VRRP commands in the Command Line Interface (CLI) are listed, along with the appropriate parameters, in the following table. Command enable vrrp disable vrrp create vrrp vrid config vrrp vrid create vrrp ipif config vrrp ipif show vrrp delete vrrp Parameters {ping} {ping} ipif ipaddress {state [enable | disable] | priority | advertisement_interval | preempt [true | false] | critical_ip | critical_ip_state [enable | disable]} ipif {state [enable | disable] | priority | ipaddress | advertisement_interval | preempt [true | false] | critical_ip | critical_ip_state [enable | disable]} [authtype [none | simple authdata | ip authdata ]] {ipif {vrid } {vrid ipif } Each command is listed, in detail, in the following sections. enable vrrp Purpose Syntax Description Parameters Restrictions To enable the VRRP function on the Switch. enable vrrp {ping} This command will enable the VRRP function on the Switch. {ping} - Adding this parameter to the command will allow the virtual IP address to be pinged from other host end nodes to verify connectivity. This will only enable the ping connectivity check function. To enable the VRRP protocol on the Switch, omit this parameter. This command is disabled by default. Only Administrator or Operator-level users can issue this command. 303