D-Link DGS-6600-48T Configuration Guide - Page 381

Volume 5-Multiprotocol Label Switching / Chapter 35-Virtual Private Lan Services (VPLS) Configuration Restrictions and Constants Verifying the Configuration Use the following command to check the VPLS relative information. This command can be used to check R1 and R3. MPLS-3:15(config)# show vpls detail VPLS Name: 3006, Operate Status: Up VPLS ID: 3006, Pseudowire Encap: Tagged, MTU: 0 Peers via Pseudowires: VC ID Peer Type Oper Status 3006 12.34.55.32 Network Up Local ACs: Local AC eth2.1 Oper Status ----------Up At the end of the configuration, PC1 (IP: 151.170.189.150/24) should be able to ping PC2 (IP: 151.170.189.152/24). Configuration Restrictions and Constants To support VPLS module, the software shall be able to handle MPLS, LDP and Pseudowire protocols. And, the hardware shall to be able to transmit/receive the frames on the Pseudowires and support the MAC bridge function on the VPLS. VPLS module is based on the work of MPLS and LDP module. LDP protocol needs to add MAC address withdraw message support. Constant Max VPLS entries Max Peers Max Peers per VPLS entry Max AC Max AC per VPLS entry Value 1024 2000 64 2000 64 DGS-6600 Configuration Guide 381