D-Link DGS-6600-48T Configuration Guide - Page 582

Volume 12-Troubleshooting / Chapter 59-Logging System Messages Chapter Overview 1)Define the severity level for selectively logging system messages in the local buffer. 2)Define the entry number for messages in the local buffer. 3)Display the messages stored in the local buffer. 4)Clear the local buffer. 5)Store the local buffer's messages to the system-log file on file system. 6)Upload the system-log file to a TFTP server. The following commands are used to manage the messages in the local buffer: Command logging level all show logging show logging buffer [START-INDEX [STOP-INDEX] | + NUMBER_OF_MESSAGES | NUMBER_OF_MESSAGES] clear logging logging file copy system-log tftp:\\IP-ADDRESS\[DIRECTORY\] FILENAME Explanation Specifies the severity level of messages that should be logged to the local buffer. Displays the local buffer settings. Displays the messages stored in the logging buffer. Clears the log messages in the logging buffer. Saves the contents of the local buffer to Flash memory. Uploads the the system log file to a TFTP server. In the following example, the user specifies that messages with an "Error" severity will be stored in the local buffer and verifies the configuration by displaying the logging buffer settings: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#logging level all 3 DGS-6600:15(config)#end DGS-6600:15#show logging logging on :enabled logging buffer severity:error Host Severity Facility Port Mode 10.73.87.22 warning local7 514 DGS-6600:15(config)# DGS-6600 Configuration Guide 582