D-Link DGS-6600-48T Configuration Guide - Page 583

Volume 12-Troubleshooting / Chapter 59-Logging System Messages Chapter Overview In the following example, the user displays the contents of the logging buffer, saves the entries to flash memory, clears the logging buffer, and confirms that the contents of the logging buffer have been cleared: DGS-6600:15#show logging buffer Total logs:3 Index Date Log Text 3 14:27:50, 2012-05-24 Interface eth4.47 is up 2 14:27:50, 2012-05-24 Interface vlan1 is up 1 14:22:34, 2012-05-24 System is cold started DGS-6600:15#configure terminal DGS-6600:15(config)#logging file DGS-6600:15(config)#end DGS-6600:15#clear logging DGS-6600:15#show logging buffer Total logs:0 DGS-6600:15# In the following example, the user uploads the system log to a TFTP server with the IP address 10.73.87.88: DGS-6600:15#copy system-log tftp:\\10.73.87.88\system-log.txt System-log has been copied successfully. DGS-6600:15# In the following example, the user saves the entries in the log to flash memory and views the contents of the flash directory to verify that the log file has been saved properly: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#logging file DGS-6600:15(config)#end DGS-6600:15#dir flash:\log system_log.txt DGS-6600:15# 286 bytes Logging System Messages to a Syslog Server The user can configure the Switch so that system messages are logged to a remote Syslog server. The user can also apply a severity level filter, which only logs messages of the specified severity level to the Syslog server. Up to four Syslog servers can be configured on the Switch. DGS-6600 Configuration Guide 583