D-Link DGS-6600-48T Configuration Guide - Page 544

Volume 10-Network Management / Chapter 54-RMON Configuration Examples Configuring rmon statistics This command allows the administrator to enable or disable RMON on Ethernet interfaces of the device. If the administrator enables the RMON mechanism on the specific interface, the device will automatically collect statistical information about the traffic for the interface. The administrator can also perform operations on the supported MIB RMON groups. Command rmon statistics ENTRY-NUMBER [owner NAME] no rmon statistics ENTRY-NUMBER Explanation Use the rmon collection stats interface configuration command to collect Ethernet group statistics. Use the no form of this command to return to disable RMON entry. This example shows how to create two RMON entries on Ethernet interface 3.2: DGS-6600>configure terminal DGS-6600(config)#interface eth3.2 DGS-6600(config-if)#rmon statistics 3 owner monitor DGS-6600(config-if)#rmon statistics 4 This example shows how to disable the RMON entry on Ethernet interface 3.2: DGS-6600>configure terminal DGS-6600(config)#interface eth3.2 DGS-6600(config-if)#no rmon statistics 3 Configuration Examples RMON Configuration Example Remote Monitoring (RMON) is a standard monitoring specification that enables various network monitors and console systems to exchange network-monitoring data. By default the DGS-6600 RMON is enabled. In the following example we use RMON to collect ethernet group statistics. Topology Figure 54-1 RMON Configuration Topology DGS-6600 Configuration Guide 544