D-Link DGS-6600-48T Configuration Guide - Page 581

Volume 12-Troubleshooting / Chapter 59-Logging System Messages Chapter Overview Level Number Severity Level Description 6 Informational Informational messages. 7 Debugging Debugging messages. Table 59-1 Descriptions of Severity Levels for Syslog Error Messages (continued) Logging System Messages Configuration Commands The following topics are included in this section. • Logging System Messages Configuration Commands • Managing Messages in the Local Buffer • Logging System Messages to a Syslog Server Enabling System Message Logging The logging function on the Switch must be enabled in order for the Syslog process to log system messages in the local buffer or report system messages to a Syslog server. To enable system message logging and display the logging settings, enter the following commands in global configuration mode: Command logging on logging level all end show logging Explanation Enables the logging function. Specifies the severity level of the messages that should be captured. Exits global configuration mode. Displays the logging settings. In the following example, the user enables message logging, specifying that severity level 4 messages should be logged, and displays the logging settings: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#logging on DGS-6600:15(config)#logging level all 4 DGS-6600:15(config)#end DGS-6600:15#show logging logging on :enabled logging buffer severity:warning Host Severity Facility Port Mode 10.1.2.111 warning local7 514 DGS-6600:15(config)# Managing Messages in the Local Buffer The user can manage the messages in the local buffer in the following ways: DGS-6600 Configuration Guide 581