D-Link DXS-3400 Emulator - Page 10

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch CLI Reference Guide After the switch was rebooted, or when the users logs out and back in, the newly created username and password must be entered to access the CLI interface again, as seen below. DXS-3400-24TC TenGigabit Ethernet Switch Command Line Interface Firmware: Build 3.00.013 Copyright(C) 2019 D-Link Corporation. All rights reserved. User Access Verification Username:admin Password:***** Switch# Interface Notation When configuring the physical ports available on this switch, a specific interface notation is used. The following will explain the layout, terminology and use of this notation. In the following example, we'll enter the Global Configuration Mode and then enter the Interface Configuration Mode, using the notation 1/0/1. After entering the Interface Configuration Mode for port 1, we'll change the speed to 1 Gbps, using the speed 1000 command. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# speed 1000 Switch(config-if)# In the above example the notation 1/0/1 was used. The terminology for each parameter is as follows: • Interface Unit's ID / Open Slot's ID / Port's ID The Interface Unit's ID is the ID of the stacking unit without the physical stack. If stacking is disabled or this unit is a stand-alone unit, then this parameter is irrelevant. The Open Slot's ID is the ID of the module plugged into the open module slot of the switch. The DXS-3400 Series switch doesn't support any open modules slots, thus this parameters will always by zero for this switch series. Lastly, the Port's ID is the physical port number of the port being configured. In summary the above example will configure the stacked switch with the ID of 1, with the open slot ID of 0, and the physical port number 1. Error Messages When the users issue a command that the switch does not recognize, error messages will be generated to assist users with basic information about the mistake that was made. A list of possible error messages are found in the table below. Error Message Ambiguous command Incomplete command Invalid input detected at ^marker Meaning Not enough keywords were entered for the switch to recognize the command. The command was not entered with all the required keyword. The command was entered incorrectly. 6