D-Link DXS-3400 Emulator - Page 1141

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch CLI Reference Guide a matched VLAN Name. Note: A tag field of greater than 0x1F is interpreted as the first octet of the following field. If the user has configured the VLAN attribute of the RADIUS server (for example, VID 3) and the 802.1X, or MAC based Access Control, or WAC authentication is successful, the port will be assigned to VLAN 3. However if the user does not configure the VLAN attributes, when the port is not guest VLAN member, it will be kept in its current authentication VLAN, and when the port is guest VLAN member, it will be assigned to its original VLAN. To assign the ACL by the RADIUS server, the proper parameters should be configured on the RADIUS server. The table below shows the parameters for an ACL. The parameters of the Vendor-Specific Attribute are: RADIUS Tunnel Attribute Vendor-ID Vendor-Type Attribute-Specific Field Description Defines the vendor. Defines the attribute. Used to assign the ACL script. The format is based on Access Control List (ACL) commands. Value 171 (DLINK) 14 (for ACL script) ACL Script For example: ip access-list a1;permit host 10.90.90.100;exit; mac access-list extended m1;permit host 00-00-0001-90-10 any; exit; Usage Required Required Required If the user has configured the ACL attribute of the RADIUS server (for example, ACL script: ip access-list a1;permit host 10.90.90.100;exit; mac access-list extended m1;permit host 00-00-00-01-90-10 any; exit;), and the 802.1X or MAC-based Access Control WAC is successful, the device will assign the ACL script according to the RADIUS server. The enter Access-List Configuration Mode and exit Access-List Configuration Mode must be a pair, otherwise the ACP script will be reject. For more information about the ACL module, refer to the Access Control List (ACL) Commands chapter. 1137