Dell Alienware m15 R3 Service Manual - Page 34

NOTE: Ensure tha the screw holes on the display hinges are aligned with the screw holes on the palm-rest assembly.

Get Dell Alienware m15 R3 PDF manuals and user guides View all Dell Alienware m15 R3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

Steps 1. Ensure that the palm-rest assembly is placed face up with the keyboard facing you. 2. Gently place the display assembly on the palm-rest assembly. NOTE: Ensure tha the screw holes on the display hinges are aligned with the screw holes on the palm-rest assembly. 3. Align the screw holes on the display assembly with the screw holes on the palm-rest assembly. 4. Replace the eight screws (M2.5x4) that secure the display assembly to the palm-rest assembly. 5. Route the following cables to the routing guides on the palm-rest assembly. • Display cable • G-sensor cable • Tobii eye tracker cable (optional) • Antenna cables 6. Place the computer face down. 7. Connect the Tobii eye tracker cable to the connector on the system board. NOTE: This step is only applicable to computers shipped with a Tobii eye tracker. 8. Connect the G-sensor cable to the connector on the system board. 34

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
Steps
1.
Ensure that the palm-rest assembly is placed face up with the keyboard facing you.
2.
Gently place the display assembly on the palm-rest assembly.
NOTE: Ensure tha the screw holes on the display hinges are aligned with the screw holes on the palm-rest assembly.
3.
Align the screw holes on the display assembly with the screw holes on the palm-rest assembly.
4.
Replace the eight screws (M2.5x4) that secure the display assembly to the palm-rest assembly.
5.
Route the following cables to the routing guides on the palm-rest assembly.
•
Display cable
•
G-sensor cable
•
Tobii eye tracker cable (optional)
•
Antenna cables
6.
Place the computer face down.
7.
Connect the Tobii eye tracker cable to the connector on the system board.
NOTE: This step is only applicable to computers shipped with a Tobii eye tracker.
8.
Connect the G-sensor cable to the connector on the system board.
34