Dell Alienware m15 R3 Service Manual - Page 55
Power-adapter port, Removing the power-adapter port
View all Dell Alienware m15 R3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
3. In sequential order (1>2>3>4>5>6>7>8>9>10) replace the 10 screws (M2x3) that secure the fan and heat-sink assembly to the system board. NOTE: Depending on the discrete graphics processing unit installed in your computer, the number of screws securing the fan and heat-sink assembly to the system board may be 8 or 10. 4. Turn the system-board assembly over. 5. Connect the left and right fan cables to the system board. Next steps 1. Follow the procedure from step 3 to step 24 in Installing the system board. 2. Install the right IO-board. 3. Install the rear IO-cover. 4. Install the M.2 2230 solid-state drive. (if applicable) 5. Install the M.2 2280 solid-state drive. (if applicable) 6. Install the battery. 7. Install the base cover. 8. Follow the procedure in After working inside your computer. Power-adapter port Removing the power-adapter port Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. 3. Remove the battery. 4. Remove the M.2 2230 solid-state drive. (if applicable) 5. Remove the M.2 2280 solid-state drive. (if applicable) 6. Remove the rear IO-cover. 7. Remove the right IO-board. 8. Follow the procedure from step 1 to step 19 in Removing the system board. About this task The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal procedure. 55