Dell Inspiron 530 Service Manual - Page 46
Replacing the System Board Assembly - boot dvd
UPC - 883685981020
View all Dell Inspiron 530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
1 M2.5 x 5-mm screws (2) 14. Turn the computer upside down and remove the four M2 x 3-mm screws labeled "B" that secure the system board to the computer base. 1 M2 x 3-mm screws labeled "B" (4) 15. Remove the system board assembly: a. With the back of the computer facing you, grasp the upper-right corner of the system board assembly and lift it slightly; slowly easing the connectors out of their access holes on the back and side of the computer base. b. Pull the system board assembly away from you toward the front of the computer to remove the system board assembly. 1 system board assembly Replacing the System Board Assembly 1. Perform all of the steps in Removing the System Board Assembly in reverse order. NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer. 2. Turn on the computer. NOTE: If you use a BIOS update program CD to flash the BIOS, press before inserting the CD so that you can set up the computer to boot from a CD this one time only. Otherwise, you must enter the system setup program to change the default boot order. 3. Insert the flash BIOS update program CD that accompanied the replacement system board into the CD/DVD drive. Follow the instructions that appear on the screen. See Flashing the BIOS for further information.