Dell Inspiron 530 Service Manual - Page 5

Internal Card With Bluetooth, Wireless Technology

Page 5 highlights

Back to Contents Page Internal Card With Bluetooth® Wireless Technology Dell™ Latitude™ D530 Service Manual Adding the Card Removing the Card Adding the Card CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching a connector on the back panel of the computer. 1. Follow the procedures in Before You Begin. 2. Remove the hard drive (see Hard Drive). 3. Attach the card cable to the wireless card. 4. Slide the card into the computer. 1 system board connector 2 card 3 cable connector 5. Attach the card cable connector to the system board as shown in the figure above. Removing the Card CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer. If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed. 1. Follow the procedures in Before You Begin. 2. Remove the hard drive (see Hard Drive). 3. Pull the card cable connector out of the system board connector. 4. Pull the cable to remove the card from the computer.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

Back to Contents Page
Internal Card With Bluetooth
®
Wireless Technology
Dell™ Latitude™ D530 Service Manual
Adding the Card
Removing the Card
Adding the Card
1.
Follow the procedures in
Before You Begin
.
2.
Remove the hard drive (see
Hard Drive
).
3.
Attach the card cable to the wireless card.
4.
Slide the card into the computer.
5.
Attach the card cable connector to the system board as shown in the figure above.
Removing the Card
If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.
1.
Follow the procedures in
Before You Begin
.
2.
Remove the hard drive (see
Hard Drive
).
3.
Pull the card cable connector out of the system board connector.
4.
Pull the cable to remove the card from the computer.
CAUTION:
Before performing the following procedures, read the safety instructions in your
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching a connector on the back panel of the
computer.
1
system board connector
2
card
3
cable connector
CAUTION:
Before performing the following procedures, read the safety instructions in your
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.