Dell Latitude 7220 Rugged Extreme Tablet Service Manual - Page 30

Installing the heat-sink

Get Dell Latitude 7220 Rugged Extreme Tablet PDF manuals and user guides View all Dell Latitude 7220 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

NOTE: Ensure not to bend the heatsink pipe while removing the heatsink from the SSD. Do not remove the heatsink by pulling on the pipe. Carefully pry the cover from the SSD using a plastic scribe. 2. Lift the heat-sink away from the system board. Installing the heat-sink Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the heat sink and provides a visual representation of the installation procedure. Steps 1. Align the screws on the heat-sink with the screw holes on the system board. 2. Tighten the four captive screws to secure the heat-sink to the system board. NOTE: Replace the screws in the order indicated on the heat-sink. 30 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
NOTE:
Ensure not to bend the heatsink pipe while removing the heatsink from the SSD. Do not remove the heatsink
by pulling on the pipe. Carefully pry the cover from the SSD using a plastic scribe.
2.
Lift the heat-sink away from the system board.
Installing the heat-sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1.
Align the screws on the heat-sink with the screw holes on the system board.
2.
Tighten the four captive screws to secure the heat-sink to the system board.
NOTE:
Replace the screws in the order indicated on the heat-sink.
30
Removing and installing components