Dell Latitude 7220 Rugged Extreme Tablet Service Manual - Page 32
Installing the system fan
View all Dell Latitude 7220 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
3. Remove the four (M2x5) screws that secure the system fan to the system board. 4. Lift the system fan off the system board. Installing the system fan Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the system fan and provides a visual representation of the installation procedure. Steps 1. Align the screws on the system fan with the screw holes on the system board. 2. Replace the four (M2x5) screws to secure the system fan to the chassis. 3. Connect the system fan cable to the connector on the system board. 4. Route the system fan cable through the routing guide on the system fan. Next steps 1. Install the heat-sink. 2. Install the display assembly. 3. Install the batteries. 32 Removing and installing components