Dell OptiPlex GX260N User Guide - Page 60
Removing a Floppy Drive, Removing the Interposer Board, Removing the Floppy-Drive Cable
View all Dell OptiPlex GX260N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
board. 6. Remove the computer stand, if it is attached. 7. If you are installing a new floppy drive rather than replacing a drive, remove the front-panel inserts. 8. Open the computer cover. Removing a Floppy Drive 1. Disconnect the floppy-drive cable from the system board connector (DSKT). 2. Remove the power cable from the interposer board. 3. Disconnect the CD/DVD drive cable and the power cable from the CD/DVD drive. 4. Remove or raise the drive by pressing the green tabs on either side of the drive and lifting the drive up. 5. Remove the floppy-drive cable from the floppy drive. a. Remove the interposer board from the floppy drive by pressing the tab and rotating the interposer board. Removing the Interposer Board 1 floppy-drive cable 2 tab 3 interposer board 4 system board floppy-drive connector (DSKT) b. To release the floppy-drive cable from the connector, slide the lever until it is fully extended, and then lift the cable away. Removing the Floppy-Drive Cable