Dell PowerConnect 6248P Command Line Interface Guide - Page 1257

console(config)# snmp-server location New_York snmp-server user Use the snmp-server user command in Global Configuration mode to configure a new SNMP Version 3 user. To delete a user, use the no form of this command. Syntax snmp-server user username groupname [remote engineid-string] [ { authmd5 password | auth-sha password | auth-md5-key md5-key | auth-sha-key sha-key } [priv-des password | priv-des-key des-key] ] no snmp-server user username • username - Specifies the name of the user on the host that connects to the agent. (Range: 1-30 characters.) • groupname - Specifies the name of the group to which the user belongs. (Range: 1-30 characters.) • engineid-string - Specifies the engine ID of the remote SNMP entity to which the user belongs. The engine ID is a concatenated hexadecimal string. Each byte in the hexadecimal character string is two hexadecimal digits. The remote engine id designates the remote management station, and should be defined to enable the device to receive acknowledgements to "informs." (Range: 5-32 characters.) • auth-md5 - The HMAC-MD5-96 authentication level. • auth-sha - The HMAC-SHA-96 authentication level. • password - A password. (Range: 1 to 32 characters.) • auth-md5-key - The HMAC-MD5-96 authentication level. Enter a pregenerated MD5 key. • auth-sha-key - The HMAC-SHA-96 authentication level. Enter a pregenerated SHA key. • md5-key - Character string-length 32 hex characters. • sha-key - Character string-length 48 characters. • priv-des - The CBC-DES Symmetric Encryption privacy level. Enter a password. SNMP Commands 1257