Dell PowerConnect 6248P Command Line Interface Guide - Page 970

External LSDB Overflow OSPF enters this state when the number of external LSAs exceeds a configured limit, as described in RFC 1765. External LSA Count Shows the number of external (LS type 5) link-state advertisements in the link-state database. External LSA Checksum Shows the sum of the LS checksums of external link-state advertisements contained in the link-state database. New LSAs Originated Shows the number of link-state advertisements that have been originated. LSAs Received Shows the number of link-state advertisements received determined to be new instantiations. LSA Count The number of LSAs in the link state database. Maximum Number The limit on the number of LSAs that the router can store in its of LSAs link state database. LSA High Water The maximum number of LSAs that have been in the link state Mark database since OSPF began operation. Retransmit List Entries The current number of entries on all neighbors' retransmit lists. Maximum Number The maximum number of entries that can be on neighbors' of Retransmit retransmit lists at any given time. This is the sum for all Entries neighbors. When OSPF receives an LSA and cannot allocate a new retransmit list entry, the router does not acknowledge the LSA, expecting the sender to retransmit. Retransmit Entries The maximum number of retransmit list entries that have been High Water Mark on all neighbors' retransmit lists at one time. NSF Support Whether graceful restart is administratively enabled. Possible values are Support Always, Disabled, or Planned. NSF Restart Interval The number of seconds a helpful neighbor allows a restarting router to complete its graceful restart. NSF Restart Status Whether the router is currently performing a graceful restart. NSF Restart Age The number of seconds until a graceful restart expires. Only non-zero when the router is in graceful restart. NSF Restart Exit Reason The reason the previous graceful restart ended. Possible values are Not attempted, In progress, Completed, Timed out, Topology change, and Manual clear. 970 OSPFv3 Commands