Dell PowerEdge 2200 Service Manual - Page 62
Removing a Microprocessor Module From the, System Board
View all Dell PowerEdge 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
d. Lift the microprocessor module straight up and out of the microprocessor retention bracket on the system board (see Figure 4-21). microprocessor retention bracket Figure 4-21. Removing a Microprocessor Module From the System Board After installing the replacement microprocessor module and reconnecting the temperature sensor cable, change the jumber (if necessary), enter the System Setup program and confirm that the Processor 1 and Processor 2 categories correctly identify the installed microprocessor(s). Run the EISA Configuration Utility to reconfigure the system. Run the system diagnostics to verify that the new microprocessor is operating correctly. If installing a second microprocessor module, remove the terminator card (see the next subsection, "Terminator Card"). 4-20 Dell PowerEdge 2200 Systems Service Manual