Dell PowerVault 221S Rack Installation Guide - Page 14
Installing the Tower-to-Rack Conversion Kit, Removing the Bezel, Drives, Covers, and Front Panel
View all Dell PowerVault 221S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
www.dell.com | support.dell.com 5 Using two 10-32 x 0.5 Phillips screws, secure the back mounting-bracket flange to the back vertical rail. 6 Repeat steps 1 through 5 for the remaining mounting rail on the other side of the rack. 7 Ensure that the mounting rails are mounted at the same position on the vertical rails on each side of the rack. Installing the Tower-to-Rack Conversion Kit NOTE: If you have a rack-only version of the system, skip this procedure and proceed to "Installing the System in the Rack." CAUTION: Your system may be very large and heavy. To prevent personal injury, do not attempt to move the system by yourself. The tower-to-rack conversion kit includes a rack front panel with rack handles and thumbscrews. Removing the Bezel, Drives, Covers, and Front Panel 1 Shut down and turn off power to your system and disconnect your power and peripheral cables. 2 To remove the bezel (see Figure 1-7): a Using the system key, unlock the front bezel. b Swing the bezel away and down from the system until it is perpendicular to the system. c Loosen the two thumbscrews that secure the bezel hinge to the front panel (see Figure 1-7). d Pull the bezel away and set it aside. 1-10 Rack Installation Guide