Dell PowerVault MD3200i Deployment Guide - Page 68
Step 7: Connect to the Target Storage Array from the Host Server
View all Dell PowerVault MD3200i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
discovery.sendtargets.auth.username = iqn.198405.com.dell:powervault.123456 discovery.sendtargets.auth.password_in = test1234567890 If you are using SUSE Linux Enterprise Server SP3 using the GUI: 1 Click DesktopYaSTiSCSI Initiator. 2 Click Service Start, then select When Booting. 3 Select Discovered Targets, then select Discovery. 4 Enter the IP address of the port. 5 Click Next. 6 Select any target that is not logged in and click Log in. 7 Select one: • If you are not using CHAP authentication, select No Authentication. Go to step 8. or • If you are using CHAP authentication, enter the CHAP user name and password. To enable Mutual CHAP, select and enter the Mutual CHAP user name and password. 8 Repeat step 7 for each target until at least one connection is logged in for each controller. 9 Go to Connected Targets. 10 Verify that the targets are connected and displays a status of true. Step 7: Connect to the Target Storage Array from the Host Server If you are using Windows Server 2008 GUI: 1 Click Start Programs Microsoft iSCSI Initiator or click Start All Programs Administrative Tools iSCSI Initiator. 2 Click the Targets tab. If previous target discovery was successful, the iqn of the storage array should be displayed under Targets. 68 Appendix-Manual Configuration