Dell Precision 530 Service Manual - Page 83
Installing an Expansion Card
View all Dell Precision 530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
System Board Expansion Card Components AGP Pro connector 32-bit, 33 MHz PCI connector 1 PCI connector 2 PCI connector 3 64-bit, 66 MHz PCI connector 4 PCI connector 5 NOTE: Install only 66-MHz expansion cards in the 66-MHz slots. You can install 33-MHz cards in the 66-MHz slots. However, the entire bus, including the integrated SCSI controller, will operate at only 33 MHz. Installing an Expansion Card CAUTION: Before you perform this procedure, see "Safety First- For You and Your Computer." NOTICE: Before disconnecting a device from the computer, wait 10 to 20 seconds after disconnecting the computer from its electrical outlet. Before removing a component from the system board, verify that the standby power light on the system board has turned off. To locate this light, see "System Board Components." 1 Turn off the computer and devices, disconnect them from their electrical outlets, and wait 10 to 20 seconds, lay the computer on its right side, and open the computer cover. 2 Press the lever on the expansion card retention arm and raise the retention arm (see the following figure). 83