Denon AVR-1612 Owners Manual - Page 16
Preparation, Detect & Measure Main, ENTER - subwoofer
UPC - 883795002028
View all Denon AVR-1612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Basic version Advanced version STEP 1 Preparation Set up speakers (Audyssey® Auto Setup) STEP 2 Detect & Measure (Main) 4 Connect the setup microphone to the SETUP MIC jack of this unit. When the setup microphone is connected, the following screen is displayed. Audyssey Auto Setup MultEQ Preparation Connect the speakers and place them according to the recommendations in the manual. Next [ENTER] Enter [RETURN] Cancel 6 Use ui to select "Auto Setup Start" and then press ENTER. Audyssey Auto Setup Preparation Set the following items if necessary. MultEQ Pre Assign Channel Select Auto Setup Start [ENTER] Enter [RETURN] Cancel Here, we explain setup using the example of 5.1-channel speaker playback. For settings other than 5.1-channel surround, select "Pre Assign" and perform step 4 to 5 of "Set up "Pre Assign"" (vpage 40). If unused channels are set with "Channel Select", measuring time can be shortened. For setting, perform steps 7 to 11 of "Set up "Channel Select"" (vpage 41). • In STEP 2, you will perform measurements at the main listening position. • This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency. It also corrects distortion in the listening area. 7 Select "Measure" and then press ENTER. When measuring begins, a test tone is output from each speaker. • Measurement requires several minutes. 8 The detected speakers are displayed. • The illustration below shows an example of when the front speakers, center speaker, subwoofer, and surround speakers have been detected. Audyssey Auto Setup Detect Check Front Yes Center Yes Subwoofer Yes Surround Yes MultEQ 5 Select "Next" and then press ENTER. Retry Next Measure [ENTER] Enter [RETURN] Cancel NOTE If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection. 9 Use ui to select "Next → Measure" and then press ENTER. vSee overleaf Information 13