EMC CX400 Installation Guide - Page 232

Solaris Installation Checklists Task With Access Logix Without Access Logix Reference Document 7 FC4500 Storage ❑ Connect a computer to the serial ❑ Connect a computer to the serial Storage-system setup System port on the storage system. port on the storage system. guide Set properties for PowerPath For new HBAs ❑ From the computer connected to the storage system's serial port, use the following Navisphere CLI command to determine the default storage-system type: For any HBAs ❑ From the computer connected to the storage system's serial port, use the following Navisphere CLI command to determine the default storage-system type: Navisphere CLI reference navicli -np -d device systemtype navicli -np -d device systemtype where device is the name of the computer port connected to the storage-system serial port (for example, com1). where device is the name of the computer port connected to the storage-system serial port (for example, com1). If the default storage-system system type is not 3 (CLARiiON Open), use the following Navisphere CLI command to set it to 3: If the default storage-system system type is not 3 (CLARiiON Open), use the following Navisphere CLI command to set it to 3: navicli -np -d device systemtype -config 3 navicli -np -d device systemtype -config 3 CAUTION The above command CAUTION The above command reboots both SPs at the same reboots both SPs at the same time. time. 5-36 EMC Installation Roadmap for CX-Series and FC-Series Storage Systems