Electrolux E30DF74TPS Installation Instructions English - Page 17

30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS 9.3 Check Ignition on Surface Burners Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. To check for proper lighting: 1. Push in and turn a surface burner knob to the sparking position. All electronic surface ignitors will spark at the same time. Only the burner you are turning on will ignite. 2. The surface burner should light once the flow of gas reached the surface burner. Each burner should light within four (4) seconds in normal operation after air has been purged from supply lines. Visually check that burner has lit. 3. Once the burner lights, the control knob should be rotated out of the LITE position. Turn on each of the surface burners and check to see that they light properly and that the flames are even. Adjust settings if necessary. 9.4 Adjust Low Settings on Surface Burners To adjust the low setting of surface burners: 1. Push in and turn control to LITE until burner ignites. 2. Quickly turn knob to LOWEST POSITION. 3. If burner goes out, reset control to OFF. 4. Remove the surface burner control knob and decorative ring. 5. Insert a thin-bladed screwdriver into the hollow valve stem and engage the slotted screw inside. Flame size can be increased or decreased by turning the screw. Figure 30: Turn to adjust surface flame 6. Adjust flame until you can quickly turn knob from the sparking position to the lowest flame position without extinguishing the flame. Flame should be as small as possible without going out. Notes: • Air mixture adjustment is not required on surface burners. • Some models have two flames on each burner. The center flame on these burners is not adjustable. 17