Epson Stylus COLOR 3000 User Manual - Epson Stylus RIP - Page 15
Checking the Printer, Installing StylusRIP Standalone or Print Server Software - self test
View all Epson Stylus COLOR 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installing the StylusRIP Software Checking the Printer Before you install the StylusRIP software, follow the instructions in your printer's documentation to set up your printer for use, making sure you perform the following steps: If you'll be using the printer in a "typical" network configuration (described on page 5 of the Introduction), install an optional network interface card Load paper, install ink cartridges, and make sure you allow your printer to complete its entire ink charging cycle Run a printer self test to make sure it operates properly Connect the printer to the Macintosh or to the network Install any software that came with the printer, including the printer driver, utilities, and fonts Send a sample print job to make sure the interface connection is secure and the software is installed correctly Once the printer is set up and tested fully, you're ready to install the StylusRIP software on your system. Caution: Don't install the StylusRIP software until you've completely set up and tested your EPSON Stylus printer or the software may not work correctly. Installing StylusRIP Standalone or Print Server Software Follow the steps in these sections to install the software on a standalone Macintosh or on the print server system in a network. 1-2