Fujitsu S510M Operator's Guide - Page 32
Connecting ScanSnap to your Computer, Connecting the AC Adapter
UPC - 097564307324
View all Fujitsu S510M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
2.2 Connecting ScanSnap to your Computer Follow the procedure below to connect ScanSnap to your computer. 1. Connect ScanSnap to a power outlet with the AC cable. 2. Connect ScanSnap to your computer with the USB cable. ATTENTION • Be sure to connect the AC cable before connecting the USB cable. • Be sure to install ScanSnap Manager before connecting ScanSnap to your computer. [For details about the installation, refer to "Installing ScanSnap" (page 6)]. The following describes each of the above-mentioned two procedures. ■ Connecting the AC Adapter Connect the power cable as shown below. CAUTION Do not use AC adapters other than the following. Manufacturer LEI SANKEN ELECTRIC CO,. LTD AC-adapter model number NU40-2160250-I3 SEB55N2-16.0x (x= A-Z or Blank) Operation 1. Connect the AC cable to the AC adapter (collectively called the power cable) ATTENTION AC cable AC adapter Use only the supplied AC cable and AC adapter (power cable). 2. Plug the AC adapter to the AC adapter connector on the back of ScanSnap and the other end to a power outlet as shown in the figure. 16