Garmin StreetPilot 2610 Owners Manual - Page 74
Attaching the Vehicle Adapter to the StreetPilot 2610/2650, Use the AC - power cable
UPC - 753759042141
View all Garmin StreetPilot 2610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Appendix Vehicle Installation The vehicle adapter comes with an external speaker system that enables you to hear directions from your StreetPilot. Attaching the Vehicle Adapter to the StreetPilot 2610/2650 Your vehicle adapter is a 12/24 volt DC adapter with an external speaker system. This adapter is your StreetPilot's power source when you are in a vehicle (the StreetPilot does not use batteries). Use the AC adapter (included) when using the StreetPilot indoors. 1. Locate the power connector on the rear of the StreetPilot. The connector is "keyed" with a notch located towards the bottom of the plug. 2. Mate the power plug on the vehicle adapter to this connector by aligning the notches and sliding the plug into the connector until fully seated, as shown below. 3. Plug the cigarette lighter portion of the vehicle adapter into an available cigarette lighter receptacle in your vehicle. Use care when routing the adapter cable to ensure that it does not interfere with vehicle operation in any way. A 3AGC/3AG 1 amp fuse is located at the tip of the vehicle adapter Periodically, you may need to change the fuse that's located at the tip of the vehicle adapter. Simply unscrew the black, round end piece and remove/replace the fuse. 64 Attach the vehicle adapter to the back of your StreetPilot as shown above.