GE DIGIA209-160 User Manual - Page 23

Chapter 3 15 Setup Alarms Figure 9 shows the Alarms submenu. Figure 9. Alarms Digia II Menu - Alarms > Alarm Disable Alarm Frame Rate 10 f/s Quality Level 6-Highest Alarm Duration 05 Sec(s) Sensor Type NC Event Buzzer Alarm to Full Screen eMail Notification Video Loss Motion Detection Disable Motion Sensitivity 7 Select EXPORT to Copy Settings Select DISPLAY to Paste Settings Table 5. Alarms submenu Menu item Alarm # Alarm Alarm frame rate Quality level Alarm duration Sensor type Event buzzer Alarm to full screen Email notification Video loss Motion detection Motion sensitivity Motion detection grid Description The current alarm being edited. Choose between Disable, Enable, and Global. Choose between off, 1, 2, 3, 4, 5, 6, 7.5, 10, 20, and 30 fps. Choose between 1-lowest, 2, 3, 4, 5, and 6-highest. Choose between 1 and 60 seconds. Choose between NC, NO, NC Trans, and NO Trans. Check this box if you want to hear an alarm buzzer. Check this box if you want the video to become full screen when the alarm is triggered. Check this box if you want the Digia II to send an e-mail to a predetermined e-mail address when the alarm is triggered. Check this box if you want this alarm triggered when video is lost. Choose between Disable, Partial, and Full. If you set it to partial, it will take you into the motion detection grid. Choose between 1-lowest, 2, 3, 4, 5, 6, 7, 8, and 9-highest. Use the directional arrows to move the highlight square to a desired area. Enter toggles the cells on or off. When a cell is on, that area will be monitored for motion detection.