GE NX-8 Installation Manual - Page 42
Keypad sounds for Tamper Alarm.
UPC - 782136401462
View all GE NX-8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
LOC PG DESCRIPTION DEFAULT DATA L 37 21 Segment #5 (Circle numbers to program) 1 Lost Clock service LED enable. 2 Zone Doubling enable. 3 Disable on-board eight zones. 4 Enables two trips on the same cross-zone to activate the alarm. 5 Disables bypass reports for force armed zones 6 Silent exit. 7 Clock uses internal crystal. 8 Disable Temporal Siren on Fire (Do not disable on UL listed systems) L 38 21 SWINGER SHUTDOWN COUNT 0 _ L 39 21 KEYPAD SOUNDER CONTROL Segment #1 (Circle numbers to program) 1 Keypad sounds for Telephone Line Cut when in the Armed state. 2 Keypad sounds for Telephone Line Cut when in the Disarmed state. 3 Keypad sounds upon AC Power Failure. 4 Keypad sounds upon Low Battery Detection. 5 Keypad sounds during Cross Zone Trip Time. 6 Keypad sounds for Tamper Alarm. 7 Reserved. 8 Keypad sounds for expander trouble (required for UL). L 40 22 SYSTEM TIMERS Segment #1 Dynamic Battery Test duration (0-255 minutes) 0 _ Segment #2 AC Failure report delay (0-255 minutes) 5 _ Segment #3 Power Up Delay (0-60 seconds) 0 _ Segment #4 Siren Time (1-255 minutes) 8 _ Segment #5 Telephone Line Cut delay (0-255 seconds) 0 _ Segment #6 Cross Zone Time (0-255 minutes) 5 _ Segment #7 Chime Time in 50 mS increments (0-255) 3 _ Segment #8 Dialer delay ( 0-255 seconds) 0 _ Segment #9 Fire Alarm Verification Time (120-255 sec.) 0 _ Segment #10 Listen-In Time (0-255 seconds) 0 _ 41 22 SPECIAL FEATURES Segment #1 (Circle numbers to program) 1 Enables six digit code option. All arm/disarm/Go To Program codes require six digits 2 Requires valid user code entry for [r]-[9]-[8] and [r]-[9]-[9] functions to work. 3 Enable Auto Cancel / Abort. 4 Enable Walk-Test Mode. 5 Reserved. 6 Reserved. 7 Reserved. 8 Reserved. L 42 22 GO TO PROGRAM CODE 9-7-1-3-0-0 ______ Page 42