Gigabyte GA-EP45-DS3 Manual - Page 98
B. Installing Windows Vista
View all Gigabyte GA-EP45-DS3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
B. Installing Windows Vista (The procedure below assumes that only one RAID array exists in your system.) Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears, select Load Driver. (Figure 6). Figure 6 Step 2: Specify the location where the driver is saved, such as your floppy disk or USB flash drive (Figure 7). Figure 7 GA-EP45-DS3R/DS3 Motherboard - 98 -
GA-EP45-DS3R/DS3 Motherboard
- 98 -
B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears, select
Load Driver
. (Figure 6).
Step 2:
Specify the location where the driver is saved, such as your floppy disk or USB flash drive (Figure 7).
Figure 7
Figure 6