HP 1606 HP StorageWorks Fabric OS 6.3.1c Release Notes (5697-0509 September 2 - Page 40
WebTools functionality moved to DCFM, Table 6 WebTools functionality in DCFM
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
be unused and therefore contain invalid data, a CDR-1003 error message would be issued. Fabric OS 6.3.1b and later now reclassifies these messages as warnings, rather than critical errors. WebTools functionality moved to DCFM The functionality that was moved from WebTools 6.1.1 to DCFM applies to all versions of DCFM and also applies to 6.3.x. Table 6 describes these changes. Table 6 WebTools functionality in DCFM Function Add unzoned devices WebTools 6.1.0 Zone Admin DCFM Configure > Zoning Reverse Find in the zoning dialog provides the view of the zoned and unzoned devices in the fabric if all zone members are selected for Find. Comments Analyze zone config Zone Admin Configure > Zoning: Reverse Find in the zoning dialog provides the view of the zoned and unzoned devices in the fabric if all zone members are selected for Find. Device Tree and Topology: Connected End Devices: Custom display from the top level in the main frame provides the device tree and topology view for all the zoned devices if all zones are selected in the active zone configuration. Define device alias Zone Admin Device accessibility matrix Zone Admin Configure > Zoning Configure > Zoning The Compare dialog provides the Storage-Host and Host-Storage view in a tree representation that is comparable to the Device Accessibility Matrix when all devices are selected. Fabric events Fabric summary Monitor > Fabric events Monitor > Logs > Events Monitor > Reports > Fabric Reports > Fabric summary Summary report FCIP tunnel configuration Port Admin Module > GigE tab Configure > FCIP tunnel Viewing FCIP tunnels is still supported in WebTools 6.1.1, but New, Edit Config, and Delete are available only in DCFM. 40