HP 3PAR StoreServ 7450 4-node HP 3PAR StoreServ 7450 Storage Installation Guid - Page 41

Node Enclosure PCM LEDs, Controller Node LEDs

Get HP 3PAR StoreServ 7450 4-node PDF manuals and user guides View all HP 3PAR StoreServ 7450 4-node manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

2. At the rear of the storage system, verify that the controller node, I/O modules, and PCM LEDs are lit green. The controller node LEDs should be blinking green once per second. The green LED of each node will blink together when the storage cluster is properly formed. Figure 37 Node Enclosure PCM LEDs Figure 38 Controller Node LEDs NOTE: The batteries are fully charged during shipment. The batteries may loose some charge and show a degraded status immediately when power is applied. This is a temporary condition. Proceed with the system initialization process and software installation. Check the LEDs again when the installation is complete. Verifying LED Status 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
2.
At the rear of the storage system, verify that the controller node, I/O modules, and PCM LEDs
are lit green. The controller node LEDs should be blinking green once per second. The green
LED of each node will blink together when the storage cluster is properly formed.
Figure 37 Node Enclosure PCM LEDs
Figure 38 Controller Node LEDs
NOTE:
The batteries are fully charged during shipment. The batteries may loose some charge
and show a degraded status immediately when power is applied. This is a temporary condition.
Proceed with the system initialization process and software installation. Check the LEDs again
when the installation is complete.
Verifying LED Status
41