HP Cisco MDS 9120 Cisco MDS 9200 Series Hardware Installation Guide (OL-16188- - Page 93
W AC Power Supply Front Panel, Handling an 845-W AC Power Supply, Step 4
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Chapter 2 Installing the Cisco MDS 9200 Series Figure 2-21 845-W AC Power Supply Front Panel 2 PWR-845-AC 1 5 100-240V 12-5A 50/60 Hz 3 INPUT OK FAN OK OUTPUT FAIL 94976 ALL FASTENERS MUST BE FULLY ENGAGED PRIOR TO OPERATING OF POWER SUPPLY 4 Removing and Installing Components 1 Power switch 2 Power cable retainer 3 Power supply LEDs 4 AC power connection 5 Captive screw Step 4 Hold the power supply by the handle and orient it as shown in Figure 2-22, and then slide it into the power supply bay, ensuring that it is fully seated in the bay. Figure 2-22 Handling an 845-W AC Power Supply 94975 Step 5 Step 6 Tighten the power supply captive screws. Plug the power cable into the power supply, and tighten the screw on the power cable retainer to ensure the cable cannot be pulled out. Note Depending on the outlet receptacle on your power distribution unit, you may need the optional jumper power cord to connect the Cisco MDS 9200 Series to your outlet receptacle. See the "Jumper Power Cord" section on page C-11. Step 7 Connect the other end of the power cable to an AC power source. OL-16188-01 Cisco MDS 9200 Series Hardware Installation Guide 2-37