HP Cisco MDS 9124 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 831

Chapter 18 P Commands port Send documentation comments to [email protected] port To assign the TCP port number of a Gigabit Ethernet interface to the FCIP profile or a listener peer port for a ISCSI interface, use the port command. Use the no form of the command to negate the command or revert to factory defaults. port number no port number Syntax Description port number Configures a peer port. The range is 1 to 65535. Defaults Disabled Command Modes Fcip profile configuration submode. Interface configuration submode. Command History Release 1.1(1) Modification This command was introduced. Usage Guidelines Associates the profile with the assigned local port number. If a port number is not assigned for a FCIP profile, the default TCP port 3225 is used. Examples The following example configures port 5000 on FCIP interface 5. switch# config terminal switch(config)# fcip profile 5 switch(config-profile)# port 5000 The following example configures port 4000 on ISCSI interface 2/1. switch# config terminal switch(config)# interface iscsi 2/1 switch(config-profile)# port 4000 Related Commands Command show fcip profile interface fcip interface_number use-profile profile-id show interface fcip Description Displays information about the FCIP profile. Configures the interface using an existing profile ID from 1 to 255. Displays an interface configuration for a specified FCIP interface. OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 18-13