HP Cisco MDS 9124 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 923

Chapter 21 S Commands santap module Send documentation comments to [email protected] Command History Release 2.1(1a) 3.0(1) Modification This command was introduced. Added the following options: cvt-name, dvt, target-pwwn, target-vsan, dvt-name, dvt-vsan, dvt-port, lun-size-handling, and io-timeout. Usage Guidelines To access this command, you must first enable the SANTap feature on the SSM using the ssm enable feature command. When the lun-size-handling option is set (enabled), the maximum logical block addressing (LBA) for DVT LUN is set to 2 TB. As a result, there is no issue with LUN resizing. Note You can delete dvt target-pwwn using the no santap module slot dvt target-pwwn command. Other dvt options are not supported by the no form of the command. Examples The following example shows the configuration of the SSM where the SANTap feature is enabled and the VSAN used to communicate with the appliance. switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# santap module 1 appl-vsan 1 Related Commands Command ssm enable feature show santap module Description Enables the SANTap feature on the SSM. Displays the configuration and statistics of the SANTap feature. OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 21-5