HP Cisco MDS 9222i Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2 - Page 302

logging fex Chapter 4 Fabric Extender Commands Send comments to [email protected] logging fex To set the logging alert level for Fabric Extender events, use the logging fex command. To reset the logging level, use the no form of this command. logging fex [severity-level] no logging fex [severity-level] Syntax Description severity-level (Optional) Number of the desired severity level at which messages should be logged. Messages at or numerically lower than the specified level are logged. Severity levels are as follows: • 0-emergency: System unusable • 1-alert: Immediate action needed • 2-critical: Critical condition-default level • 3-error: Error condition • 4-warning: Warning condition • 5-notification: Normal but significant condition • 6-informational: Informational message only • 7-debugging: Appears during debugging only Command Default None Command Modes Configuration mode Command History Release 4.0(1a)N2(1) Modification This command was introduced. Examples This example shows how to set the logging alert level for Fabric Extender events: switch(config)# logging fex 4 This example shows how to reset the logging level: switch(config)# no logging fex Related Commands Command show fex Description Displays all configured Fabric Extender chassis connected to the switch. Cisco Nexus 5000 Series Command Reference 4-8 OL-16599-01