HP Cisco Nexus 5000 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS R - Page 41

Caveats Send documentation comments to [email protected] • CSCsr49954 Symptom: The Recoverpoint Appliance with a QLogic HBA sends an 8 byte RFT_ID instead of the standard 32bytes, which causes FC4 features to be incorrectly registered with all features. Workaround: This issue is resolved. • CSCsr53531 Symptom: In IVR NAT environment, after active mode PortChannel flaps, some member of the PortChannel may not get programmed in the IVR table, so that related IVR traffic will get lost. Workaround: This issue is resolved. • CSCsr94621 Symptom: A Fiber Channel over IP (FCIP) trunk can go down if the maximum transmission unit (MTU in the path is less than the MTU of the MDS Gigabit Ethernet interface. Workaround: This issue is resolved. • CSCsr98144 Symptom: If a sync-loss is received for a nonexisting fabric, the xbar-manager transitions to a state from which it does not exit. Workaround: This issue is resolved. • CSCsu06940 Symptom: An Octeon core occurred. Workaround: This problem is resolved. • CSCsu31223 Symptom: A slow memory leak has been found as a part of the view of the interface table MIB with the SME interfaces. This eventually results in the SNMPD process resetting due to lack of memory. Workaround: This issue is resolved. • CSCsr02430 Symptom: After issuing the show boot command, there are duplicate image names listed in the switch output as shown below: switch# show boot sup-1 kickstart variable not set system variable = bootflash:/m9500-sf1ek9-mzg.3.4.1.bin;bootflash:/m9500-sf1ek9mzg.3.4.1.bin sup-2 kickstart variable not set system variable = bootflash:/m9500-sf1ek9-mzg.3.4.1.bin;bootflash:/m9500-sf1ek9mzg.3.4.1.bin No module boot variable set switch# This occurs if you issue the boot system command twice with the same image name as shown below: switch(config)# boot system bootflash:m9500-sf1ek9-mzg.3.4.1.bin switch(config)# boot system bootflash:m9500-sf1ek9-mzg.3.4.1.bin Workaround: This issue is resolved. • CSCsq64637 Symptom: All device aliases in Fabric Manager disappear when adding new device aliases. OL-14116-10 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2) 41