HP Dc5700 Hardware Reference Guide - dc5700 MT - Page 34

Removing Bezel Blanks, FLOPPY P10.

Get HP Dc5700 - Compaq Business Desktop PDF manuals and user guides
UPC - 882780819535
View all HP Dc5700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

NOTE If you are installing a SATA optical drive, connect the first optical drive to the white SATA connector on the system board labeled SATA1. Connect a second optical drive to the orange SATA connector labeled SATA5. If you are installing a diskette drive, connect it to the connector on the system board labeled FLOPPY P10. 5. If necessary, remove the appropriate drive bezel blank from the front bezel by pressing the two retaining tabs towards the outer left edge of the bezel (1) and pull the bezel blank inwards to remove it (2). Figure 2-22 Removing Bezel Blanks 6. Replace the removed drive bezel with the appropriate bezel by pushing the bezel into place. NOTE The type of bezel you need will depend on the type of drive you plan to install. 7. Replace the front bezel and computer access panel. 8. Reconnect the power cord and any external devices, then turn on the computer. 9. Lock any security devices that were disengaged when the access panel was removed. 28 Chapter 2 Hardware Upgrades ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
NOTE
If you are installing a SATA optical drive, connect the first optical drive to the white
SATA connector on the system board labeled SATA1. Connect a second optical drive to the
orange SATA connector labeled SATA5.
If you are installing a diskette drive, connect it to the connector on the system board labeled
FLOPPY P10.
5.
If necessary, remove the appropriate drive bezel blank from the front bezel by pressing the two
retaining tabs towards the outer left edge of the bezel (1) and pull the bezel blank inwards to remove
it (2).
Figure 2-22
Removing Bezel Blanks
6.
Replace the removed drive bezel with the appropriate bezel by pushing the bezel into place.
NOTE
The type of bezel you need will depend on the type of drive you plan to install.
7.
Replace the front bezel and computer access panel.
8.
Reconnect the power cord and any external devices, then turn on the computer.
9.
Lock any security devices that were disengaged when the access panel was removed.
28
Chapter 2
Hardware Upgrades
ENWW