HP Dc7800 Hardware Reference Guide - HP Compaq dc7800 Convertible Minitower - Page 26
Removing or Installing an Expansion Card - pci
UPC - 883585764365
View all HP Dc7800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Removing or Installing an Expansion Card The computer has three standard full-height PCI expansion slots that can accommodate an expansion card up to 34 cm (13.4 inches) in length. The computer also has two PCI Express x1 expansion slots and one PCI Express x16 expansion slot. Figure 2-9 Expansion Slot Locations Table 2-2 Expansion Slot Locations Item Description 1 PCI Express x16 expansion slot 2 PCI Express x1 expansion slot 3 PCI Express x1 expansion slot 4 PCI expansion slot 5 PCI expansion slot 6 PCI expansion slot NOTE: You can install a PCI Express x1, x4, x8, or x16 expansion card in the PCI Express x16 expansion slot. To remove, replace, or add an expansion card: 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as diskettes or compact discs, from the computer. 3. Turn off the computer properly through the operating system, then turn off any external devices. 4. Disconnect the power cord from the power outlet and disconnect any external devices. CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer. 5. Remove the computer access panel. 20 Chapter 2 Hardware Upgrades ENWW