HP EliteBook 700 Maintenance and Service Guide - Page 48
Solid-state drive, Remove the Phillips PM2.0×3.0 screw
View all HP EliteBook 700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
4. To remove the hard drive cover and bracket from the hard drive, lift the Mylar cover up off the drive, remove the four Phillips PM3.0×3.0 screws (1) that secure the bracket to the drive, and then slide the hard drive (2) out of the bracket. Reverse this procedure to install a hard drive. Solid-state drive Description 512-GB, Turbo Drive, G2, TLC 360-GB, PCIe, TLC 256-GB, Turbo Drive, G2, TLC 256-GB, SATA-3, SED, OPAL, TLC 128-GB, M.2, SATA-3 Spare part number 915943-001 915941-001 915939-001 915940-001 915938-001 Before removing the solid-state drive, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by first unscrewing the power cord from the AC outlet, and then unscrewing the AC adapter from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 33). 5. Disconnect the battery (see Battery on page 36). Remove the solid-state drive: 1. Remove the Phillips PM2.0×3.0 screw (1) that secures the drive to the system board. 38 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts