HP Jetdirect 610n HP Jetdirect 610n EIO Print Server - (English) Hardware Inst - Page 23

/100Base-TX Link Configuration, Introduction - print server j4169a

Get HP Jetdirect 610n PDF manuals and user guides View all HP Jetdirect 610n manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

3 10/100Base-TX Link Configuration Introduction HP J6057A (615N) or J4169A (610N) 10/100Base-TX print servers support 10 or 100 Mbps operation using full-duplex or half-duplex transmission channels. By default, the print server will attempt to autonegotiate its link operation. When connecting to network hubs and switches that do not support autonegotiation, the print server will configure itself for 10-Mbps or 100-Mbps half-duplex operation. For example, when connected to a non-negotiating 10 Mbps hub, the print server card will automatically set itself to operate at 10-Mbps half-duplex. If the card is not able to connect to the network through autonegotiation, you can manually set the link operating mode using one of the following methods: q the printer's control panel (if it has one). See Appendix A for more information. q the embedded web server running on the Jetdirect print server. q accessing the Telnet interface on the Jetdirect print server. q using a TFTP (Trivial File Transfer Protocol) file downloaded, for example, from a BootP or DHCP server. ENWW 10/100Base-TX Link Configuration 3-23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
10/100Base-TX Link Configuration 3-23
ENWW
3
10/100Base-TX Link Configuration
Introduction
HP J6057A (615N) or J4169A (610N) 10/100Base-TX print servers
support 10 or 100 Mbps operation using full-duplex or half-duplex
transmission channels. By default, the print server will attempt to
autonegotiate its link operation.
When connecting to network hubs and switches that do not support
autonegotiation, the print server will configure itself for
10-Mbps
or
100-Mbps half-duplex
operation. For example, when connected
to a non-negotiating 10 Mbps hub, the print server card will
automatically set itself to operate at
10-Mbps half-duplex
.
If the card is not able to connect to the network through
autonegotiation, you can manually set the link operating mode
using one of the following methods:
●
the printer
’
s control panel (if it has one). See
Appendix A
for more
information.
●
the embedded web server running on the Jetdirect print server.
●
accessing the Telnet interface on the Jetdirect print server.
●
using a TFTP (Trivial File Transfer Protocol) file downloaded, for
example, from a BootP or DHCP server.