HP Jetdirect 610n HP Jetdirect 610n EIO Print Server - (English) Hardware Inst - Page 25

Base-TX Link Configuration 3-25, HP Jetdirect, Administrator, s Guide

Get HP Jetdirect 610n PDF manuals and user guides View all HP Jetdirect 610n manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Try the following troubleshooting procedures: q Verify cabling connections. q Configure the print server's 10/100TX link setting directly (for example, using the EIO menu on the printer's control panel). Verify that the configuration of the connecting network device (such as a network switch) matches. For example, if you set the print server for 100Base-TX Full-Duplex operation, the port on the network switch must also be set to 100Base-TX Full-Duplex operation. Power-cycle the printer to reinitialize the setting. q On the Jetdirect Configuration Page, compare your configuration for the following parameters: Parameter PORT SELECT: PORT CONFIG: AUTONEGOTIATION: Expected Messages for 10/100TX Cards RJ-45 100TX HALF, 100TX FULL, 10BASE-T HALF, 10BASE-T FULL ON (Autonegotiation is enabled), or OFF (Autonegotiation is disabled, 10/100TX configuration has been manually set) For other configuration parameters and messages on the Jetdirect Configuration Page, refer to the applicable HP Jetdirect Administrator's Guide provided on the HP Jetdirect CD-ROM. ENWW 10/100Base-TX Link Configuration 3-25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
10/100Base-TX Link Configuration 3-25
ENWW
Try the following troubleshooting procedures:
●
Verify cabling connections.
●
Configure the print server
’
s 10/100TX link setting directly (for
example, using the EIO menu on the printer
’
s control panel).
Verify that the configuration of the connecting network device
(such as a network switch) matches. For example, if you set the
print server for 100Base-TX Full-Duplex operation, the port on
the network switch must also be set to 100Base-TX Full-Duplex
operation. Power-cycle the printer to reinitialize the setting.
●
On the Jetdirect Configuration Page, compare your configuration
for the following parameters:
For other configuration parameters and messages on the Jetdirect
Configuration Page, refer to the applicable
HP Jetdirect
Administrator
’
s Guide
provided on the HP Jetdirect CD-ROM.
Parameter
Expected Messages for 10/100TX Cards
PORT SELECT:
RJ-45
PORT CONFIG:
100TX HALF, 100TX FULL, 10BASE-T HALF,
10BASE-T FULL
AUTONEGOTIATION:
ON (Autonegotiation is enabled), or
OFF (Autonegotiation is disabled, 10/100TX
configuration has been manually set)