HP Model 735 hp 12x speed CD-ROM disk drive user's guide (a1658-90703) - Page 18

Address Jumpers

Get HP Model 735 - Workstation PDF manuals and user guides View all HP Model 735 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Introduction Address Jumpers To set the drive's address, use the SCSI address jumpers. Perform the following steps to set the drive's address: 1. Attach the static-grounding wrist strap by following the instructions on the package that contains the strap. Attach one end of the strap to the system chassis. 2. Locate the address jumpers on the rear of the CD-ROM drive, as shown in Figure 1-3. 3. Set the drive's SCSI target address to an address that's not used by another SCSI device. Use jumpers, as shown in Figure 1-3. NOTICE: Do not use SCSI address 7 because the system's SCSI controller uses address 7 by default. We advise that you do not use SCSI address 6 because the root disk drive uses it. SCSI ID 0 1 2 default 3 SCSI ID 4 5 6 Figure 1-3. SCSI Address Settings 1-8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
Introduction
1–8
Address Jumpers
To set the drive’s address, use the SCSI address jumpers. Perform the following steps to
set the drive’
s address:
1.
Attach the static-grounding wrist strap by following the instructions on the package
that contains the strap. Attach one end of the strap to the system chassis.
2.
Locate the address jumpers on the rear of the CD-ROM drive, as shown in
Figure 1–3.
3.
Set the drive’s SCSI target address to an address that’s not used by another SCSI
device. Use jumpers, as shown in Figure 1–3.
NOTICE:
Do not
use SCSI address 7 because the system’s SCSI controller
uses address 7 by default. We advise that you
do not
use SCSI
address 6 because the root disk drive uses it.
SCSI ID
3
2
default
1
4
5
6
SCSI ID
0
Figure 1–3.
SCSI Addr
ess Settings