HP P2000 HP P2000 G3 MSA System CLI Reference Guide - Page 147

set ntp-parameters Description Sets Network Time Protocol (NTP) parameters for the system. Date and time values use Coordinated Universal Time (UTC). You can manually set system date and time parameters by using the set controller-date command. Syntax set ntp-parameters ntp enabled|disabled|on|off ntpaddress IP-address timezone +|-hh[:mm] Parameters ntp enabled|disabled|on|off Enables or disables use of NTP. When NTP is enabled and the specified NTP server is available, each controller's time is synchronized with the server. ntpaddress IP-address The network address of an available NTP server. timezone +|-hh[:mm] The system's time zone as an offset in hours (-1 to -12, +1 to +13) and minutes (0-59) from UTC. For example, the Pacific Time Zone offset is -8 during Pacific Standard Time or -7 during Pacific Daylight Time. Example Set the system to use NTP with an offset for Mountain Standard Time: # set ntp-parameters ntp enabled ntpaddress 69.10.36.3 timezone -7 Success: Command completed successfully. Set the system to use NTP with an offset for the Bangalore, India time zone: # set controller-date ntp enabled ntpaddress 69.10.36.3 timezone +5:30 Success: Command completed successfully. See also • set controller-date • show controller-date • show ntp-status HP P2000 G3 MSA System CLI Reference Guide 147