HP Pavilion 13-u100 Maintenance and Service Guide - Page 61
Remove the ten Phillips PM2.0×4.7 screws that secure the system board to the base enclosure.
View all HP Pavilion 13-u100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
2. Disconnect the following cables from the system board: (6) Mass storage device ZIF connector cable (7) Display panel cable (8) Power connector cable 3. Remove the ten Phillips PM2.0×4.7 screws that secure the system board to the base enclosure. 4. Lift the left side of the system board (1) until it rests at an angle. Component replacement procedures 53
2.
Disconnect the following cables from the system board:
(6)
Mass storage device ZIF connector cable
(7)
Display panel cable
(8)
Power connector cable
3.
Remove the ten Phillips PM2.0×4.7 screws that secure the system board to the base enclosure.
4.
Lift the left side of the system board
(1)
until it rests at an angle.
Component replacement procedures
53